- Israel
- 5+ years
Hardware engineer owning the ATE and test hardware for cellular IoT chipset programs
Responsibilities
- Own ATE/test hardware end to end — DUT/load boards, multi-site boards, characterization setups — through schematic, layout, fabrication, bring-up, and correlation.
- Drive test-system debug to root cause (signal integrity, board-tester interface, yield/correlation) and support device characterization and screening.
- Debug on-site at partner and test-house locations, including international travel.
- Design RF/analog front-end circuitry for test and evaluation: RF chains, matching networks, switch topologies, and interfaces.
- Design multilayer PCBs (incl. high-layer-count with blind/buried vias) in Cadence Allegro/OrCAD, with clean, manufacturable fab/assembly outputs (Gerber/ODB++, DFM, stackup/impedance).
Requirements
- B.Sc. in Electrical/Electronic Engineering
- Nice to have: specific ATE/tester family
- Nice to have: multi-site DUT board design
- Nice to have: Cellular modem integration (LTE-M / NB-IoT)
- Nice to have: C