The Process Engineer will support wafer probe operations for both product development and high-volume manufacturing environments. This role is responsible for developing, sustaining, and optimizing wafer probe processes, test methodologies, SPC systems, probe card configurations, and test setup infrastructure.
Compensation
The salary range is what we believe to be the range of possible compensation for this role at the time of this posting. We may ultimately pay more or less than the posted range and this range is only applicable for jobs to be performed in California, Colorado, New York or remote jobs that can be performed in California, Colorado and New York.
Responsibilities
Develop, qualify, and sustain wafer probe processes for new and existing products
Define, validate, and maintain probe card configurations and wafer test setups
Monitor and optimize process performance using SPC, EDC, and statistical analysis
Investigate process excursions and implement data-driven corrective actions
Lead wafer probe readiness for New Product Introductions (NPI)
Independently develop, and document test procedures based on leadership input. Represent lab in technical discussions and provide strategic direction and implementation of lab testing for an extensive range of new product types and major product improvements.
Compensation
The hourly pay for this role is $30.00 – $40.00/hour, DOE.
Responsibilities
Assemble, wire, configure, and troubleshoot electrical and electromechanical test setups, fixtures, and prototype assemblies, including soldering, connector installation, wire termination, and prototype rework.
Set up and operate oscilloscopes, digital multimeters, power analyzers, programmable power supplies, electronic loads, and data acquisition systems.
Perform functional, performance, endurance, and environmental testing on products and components according to approved test plans.
Read and interpret electrical schematics, wiring diagrams, assembly drawings, and component specifications, and support engineers with failure investigations and diagnostic testing.
Represent the lab in technical discussions and research, source, and train on new laboratory testing equipment.
Requirements
Associate’s degree or technical diploma in Electrical Engineering Technology, Electronics, Industrial Controls, Mechatronics, or a related discipline
Nice to have: Testing motors
Nice to have: Testing variable-speed drives
Nice to have: Testing embedded controls
Master Thesis: Measuring the electrical limits of dielectric thin films for MEMS
Provide daily production-floor engineering support across disassembly, preparation/paint, and assembly operations for Genie mobile elevating work platforms.
Apply engineering analysis and independent technical judgment to diagnose recurring production problems, determine root causes, and implement verified corrective actions.
Develop, validate, document, and improve production processes, standard work, workstation layouts, and assembly methods.
Analyze cycle times, constraints, ergonomics, first-pass quality, safety, downtime, and rework; implement measurable improvements in throughput and cost.
Collaborate with Operations, Quality, Supply Chain, Maintenance, EHS, and Product Engineering to resolve manufacturing constraints and ensure process readiness.
Requirements
Bachelor’s degree in Electrical Engineering, Electrical and Computer Engineering, or a closely related engineering discipline
Nice to have: Experience with heavy industrial equipment, aerial work platforms, or equipment reconditioning
Nice to have: Experience with lean manufacturing, 5S, root cause analysis, process validation, and continuous improvement
Nice to have: Experience with Infor CloudSuite Industrial (SyteLine), production data systems, or comparable ERP/MRP tools
Nice to have: Integrating electrical testing with pressure, flow, temperature, or other performance measurements