- Dallas, Texas, United States
- On-site
- Full-time · Mid
- 3+ years
The Injection Mold Design Engineer is responsible for material selection, injection molding design, tooling feasibility, process development support, and molded-product reliability for Premier PV’s solar eBOS products.
Responsibilities
- Serve as Premier PV’s Design Engineer supporting Engineering Managers for injection molding, overmolding, insert molding, resin selection, moldability, and molded-product architecture.
- Support design and development of overmolded PV harness products, inline fuse assemblies, molded strain reliefs, connector interfaces, molded housings, and related eBOS components.
- Evaluate and recommend polymer/material systems including PPS, PPA, TPV, LSR, PP-based compounds, thermally conductive electrically insulating compounds, and other engineered materials for outdoor PV use.
- Review and interpret material properties including RTI, UL Yellow Card data, f1/f2 outdoor suitability, dielectric strength, CTI, flammability, water absorption, thermal conductivity, shrink rate, and long-term aging behavior.
- Assist with mold design input for gate location, runner strategy, parting line, venting, flash control, weld-line risk, wire positioning, insert retention, wall thickness, draft, ribs, bosses, radii, and dimensional stability.
Requirements
- Bachelor’s degree in Mechanical Engineering
- Plastics Engineering
- Polymer Engineering
- Materials Science
- Manufacturing Engineering