Entry-Level Design Evaluation Engineer to evaluate power-management integrated circuits in a laboratory setting.
Compensation
The expected wage range for a new hire into this position is $100,266 to $137,892.
Responsibilities
Perform hands‑on laboratory evaluation and characterization of power‑management ICs
Support first‑silicon and evaluation‑board bring‑up
Execute validation plans across operating conditions
Measure parameters such as output accuracy, line and load regulation, efficiency, power loss, quiescent current, ripple, noise, transient response, switching behavior, current limit, and thermal performance
Capture and analyze oscilloscope waveforms for dynamic behavior
Requirements
Master’s degree in Electrical Engineering, Electronics Engineering, Computer Engineering, or a closely related engineering discipline
Support design verification and production validation of a high voltage zonal control module through vehicle launch. The engineer works hands on in the client's HV lab executing component, board and module level test campaigns, building the automated setups that run them, and turning raw data into failure analysis the design team can act on.
Compensation
Base salary range: $100,000 to $110,000 (maximum base salary)
Responsibilities
Execute DV and PV test campaigns on high voltage zonal module hardware, including relay life cycle testing to defined cycle counts, low temperature validation and environmental stress testing.
Build and operate bench setups using oscilloscopes, DMMs, programmable power supplies, power amplifiers, electronic loads and signal generators.
Write Python automation to drive instrumentation and sweep test parameters.
Perform component and board level characterization: buck and boost converter validation, SPI bus characterization, high side driver characterization under representative capacitive loading, and repeat run characterization across 100 plus iterations to surface intermittent failures.
Capture and reduce test data, run first pass failure investigation, and hand findings to the responsible design engineer with a clear recommendation.
Requirements
Bachelor's in Electrical Engineering, Computer Engineering or a related field.
Hands‑on optical characterization and correlation study to improve silicon photonics product testing.
Compensation
Hourly Rate in USD
$43—$47 USD
Responsibilities
Characterize a set of silicon photonics units on bench optical instrumentation, measuring output power, modulation amplitude, extinction ratio, and wavelength.
Build automation to run measurements, control the lab setup, and log results in a consistent, reusable data format.
Correlate unit measurements against a calibrated laboratory reference and quantify per-unit offsets and population spread.
Measure unit stability across time, temperature, and repeated re‑insertion, and analyze repeatability and drift.
Deliver a feasibility and gap assessment with a clear recommendation, including the calibration and maintenance scheme needed for production deployment.
Requirements
Bachelor's program in Electrical Engineering
Bachelor's program in Physics
Bachelor's program in Optical Engineering
Nice to have: research, lab, or prior internship experience in photonics or semiconductors
Nice to have: experience automating lab instruments (PyVISA, SCPI, or similar)
Lead test planning, interface architecture, and payload validation for satellite communications payloads within the Assembly, Integration & Test team.
Locations (3)
Tempe, Arizona, United States
San Jose, California, United States
New York City, New York, United States
Compensation
$95,000.00 - $149,500.00 / annually. For specific work locations within San Jose, the San Francisco Bay area and New York City metropolitan area, the base pay range for this role is $117,500.00- $176,500.00/ annually
Responsibilities
Collaborate closely with multidisciplinary teams, partnering daily with mechanical, software, and systems engineers.
Coordinate test planning, facility readiness, interface compatibility, and campaign schedules with external subcontractors, satellite bus providers, and hardware vendors.
Develop and maintain detailed test matrices, operational cross-connect routing grids, and requirements verification cross-reference matrices (VCRMs).
Design and update Interface Control Documents (ICDs), rack elevation drawings, RF switch matrix schematics, and interconnect block diagrams using Microsoft Visio, Draw.io, or equivalent diagramming tools.
Proactively leverage AI engineering tools and workflow automation to accelerate technical documentation, summarize complex test data, and optimize testing logistics.